hlax

A command of the separate bcma command line; see Commands for other chip families.

Hardware License Authentication control.

hlax add <license-file> [<appl-image> [<arg> ...]]
clean
apply [<license-file> [<appl-image> [<arg> ...]]]
status
run [<arg> ...]
result
reinit

Built-in help

add    - Add license file to the device database, but do not
         load it. An optional application image which can be
         authorized by the license file can be specified after the
         license file with optional application arguments to follow.
clean  - Remove all license files from the device database.
apply  - If no license file is specified, license file(s) in
         the device database will be loaded into the switch.
         If a license file is specified, then this file will
         be added to the device database first.
status - Show status of the HLA sub-system.
run    - Run the application again from the previously loaded license
         file. Optional 32-bit application arguments can be specified.
result - Show results from the previously executed application.
         Note that retrieving application results could cause a state
         change in the HLA sub-system.
reinit - Re-initialize the communication channel between the SDK and
         the HLA sub-system in case an out-of-sync condition is
         observed.

Built-in examples

clean
add license.bin
add license.bin appl.bin 0x1234 0xffffffff
apply
apply license.bin appl.bin
status
run
run 0x12345678 0x1200 0xff
result
reinit