FlowTracker

Note

This command belongs to the shell mode for newer (logical-table) switch chips and is not available on Trident 3.

Flowtracker sw state

Shortest form: ft.

Built-in help

    help
    flowtracker sw show
    flowtracker bs show group|drop|check ID=<group_id|check_id>
    flowtracker bs list param ift|mft|eft|aift|amft|aeft|all
    flowtracker bs list drop ingmmu|egr|agg_ingmmu|agg_egr|all
    flowtracker bs rmon <options>
        Parameters: [report +/-<values>] [stop|start] [count]
        log # - specifies # packets to remember

        dump [# | options] - # > 0 dumps # packets from start of log
                         # < 0 dumps last # packets

                         nothing - dumps all logs
                         options - count   - print packet # only
                                   decode  - attempt to decode packet
                                   raw     - dump raw byte stream (host
                                           order)
                                   Prepend + to set, - to clear, nothing
                                           to toggle
        report- count   - print packet # only
                decode  - attempt to decode packet
                raw     - dump raw byte stream (host order)
                pmd     - dump packet metadata information
                Prepend + to set, - to clear, nothing to toggle
        quiet - disable all reporting
        start - start the FtRemoteMon-daemon
        stop  - stop the FtRemoteMon-daemon and deallocate log space
        count - print # packets received.
        reset - reinitialize configuration from bcm_rx_* API state
.
    flowtracker bs lmon <options>
        Parameters: [report +/-<values>] [stop|start]
        report- decode  - attempt to decode packet
                Prepend + to set, - to clear, nothing to toggle
        start - start the FtLocalMon-Callback
        stop  - stop the FtLocalMon-Callback