`SOC`

Print internal Driver control information

Print the SDK driver’s internal control information for the unit, or for each unit number given: the attach state, DMA channel and interrupt settings and other driver bookkeeping. Read-only. The built-in help says this works only in debug builds; in this build the full dump is available.

Hardware-validated

drivshell> soc
  Unit 0 Driver Control Structure:
  Chip=BCM56870_A0 Rev=0x01 Driver=BCM56870_A0
  Flags=0x48103: attached initialized mem-clear-use-dma; board type 0x0
  CM: Base=0x7fe873800000
  Disabled: reg_flags=0x100 mem_flags=0x0
  SchanOps=1835219172 MMUdbg=0 LinkPause=0
  Counter: int=1000000us per=1128208us dmaBuf=0x7fe871830280
           EvictInvalidPoolIdCount=0
           BulkDmaErrorCount=0
           CounterDmaDurationUsec=15663
           CounterErrorRestartCount=0
  Timeout: Schan=0(300000us) MIIM=0(1000000us)
           SchanMemRead=0 SchanMemWrite=0
           SchanRegRead=0 SchanRegWrite=0
           SchanTblInsert=0 SchanTblDelete=0 SchanTblLookup=0
  Intr: Total=18547853 Sc=0 ScErr=0 MMU/ARLErr=0
        LinkStat=0 PCIfatal=0 PCIparity=0
        ARLdrop=0 ARLmbuf=0 ARLxfer=0 ARLcnt0=0
        TableDMA=18577868 TSLAM-DMA=401 CCM-DMA=0 SW=0
        MemCmd[BSE]=0 MemCmd[CSE]=0 MemCmd[HSE]=0
        ChipFunc[0]=0 ChipFunc[1]=0 ChipFunc[2]=0
        ChipFunc[3]=0 ChipFunc[4]=0
        FifoDma[0]=40 FifoDma[1]=0 FifoDma[2]=0 FifoDma[3]=0
        I2C=0 MII=0 StatsDMA=0 Desc=0 Chain=0 PciTimeOut=0
        DmaAddrDecodeErr=0 SbusDmaSwTimeout=0
  Error: SDRAM=0 CFAP=0 Fcell=0 MmuSR=0 l2FifoDMA=0
  M0: msg=3 resp=3 intr=0
  Uc sw programmable total intr=0
  M0 sw programmable intr: u0=0 u1=0 u2=0 u3=0
  SBUS DMA err_intr_res=0
...

Built-in help

Parameters: [<unit #>] ...
    Print internal SOC driver control information IF compiled as a
    debug version. If not compiled as a debug version, a warning is
    printed and the command completes successfully with no further
    output

SOC

`SOC`